© Educational Video Network, Inc. 2005 - www.evndirect.com
Your leading source for curriculum-based educational videos and DVDs.
Order this item online today!
|
Study Guide Questions
|
1.
What should you check before you try to begin this job?
|
2.
What equipment is needed for this particular job?
|
3.
What extra tools may be needed for this job?
|
4.
What should always wear when doing repair work?
|
5.
Some instructions ask you to keep all four of the vehicle's wheels on the ground. True or false?
|
6.
There are __________________ different types of shock mounts. What are they?
|
7.
Set an automatic transmission in "________________________________."
|
8.
Put a manual transmission __________________________________________.
|
9.
What should you do with the rear wheels when replacing front shocks?
|
10.
Initially, loosen lug nuts ______________________ turn.
|
11.
Check your owner's manual for the correct jack positioning. True or false?
|
12.
Allow full spring _______________________________ or ________________________.
|
13.
Throughout the procedure, support the vehicle's weight on the jack. True or false?
|
14.
When do you completely remove the lug nuts?
|
15.
After removing the front wheel, locate the _________________________ mount.
|
16.
What are some signs of worn out, or bad, shock absorbers?
|
17.
If the shock absorber shaft turns as you attempt to unthread the nut, you must ___________________________________________________ .
|
18.
Do not lie under the ________________________________________________________.
|
19.
What can you do if the shock nuts won't loosen?
|
20.
Depending on the height of the car off the ground, what may it be necessary to do to remove the shock absorber from the car?
|
21.
Begin by installing a new ____________________________ and _____________________ onto the shock absorber.
|
22.
Place the washer on the shock shaft ___________________________ -side upward.
|
23.
Slide the bushing onto the shock shaft ________________________-side down.
|
24.
Make sure that the shock's mounting surfaces _____________________________________ and _____________________________________________________________.
|
25.
Over-tightening may ________________________________ the bolts.
|
26.
Always tighten lug nuts in a(n) _________________________________ fashion.
|
27.
When replacing rear shocks, what should you do to the front wheels of the vehicle?
|
28.
In cars with coil springs, support the rear ______________________________________.
|
29.
The shock absorber may be shorter than the ______________________________ of the suspension system.
|
30.
What may you have to remove in certain station wagons or vans?
|
31.
Install conical washers and bushings in the correct _________________________________.
|
32.
Torque the stud into position, using a(n) _______________________________ wrench.
|
© Educational Video Network, Inc. 2005 - www.evndirect.com
Your leading source for curriculum-based educational videos and DVDs.
|