© Educational Video Network, Inc. 2005 - www.evndirect.com
Your leading source for curriculum-based educational videos and DVDs.
Order this item online today!

Study Guide Answers

1.     Why do you have to remove the battery when you are working on a transaxle?
     The starter that you're taking out is connected to the transaxle and you have to make sure that the heavy positive is loose.
2.     The ____________ ________________ cable is activated by the clutch foot pedal.
     clutch release
3.     What must you do to the car before jacking it up?
     Set the parking brake, loosen the lug nuts, release the steering lock, put the car in neutral, and place a bar on top that can support the engine.
4.     What does the shifter tube do?
     It connects the shifter handle in the car to the transaxle itself.
5.     What does the transaxle brace connect?
     It connects the chassis to the transaxle.
6.     Remove asbestos fibers from the transaxle using __________________ cleaner.
     brake
7.     The _________________ ____________ is coupled between the pressure plate and the fly wheel.
     friction disk
8.     Why must you remove the bolts from the clutch in a star pattern?
     This will prevent the pressure plate from warping.
9.     How do you know when the clutch disk needs replacing?
     It should be replaced if it is worn down or black inside.
10.     Use a pry bar to hold the __________ _____________ in place while removing the bolts.
     fly wheel
11.     Replace the ______________ bearing when you replace the clutch.
     release
12.     Why should the surface where the engine block and the transaxle meet be clean?
     This will prevent clutch misalignment.
13.     Tighten the bolts on the fly wheel in a _______________________ pattern.
     criss-cross
14.     _______________ the bolts so that they are held evenly and so the stress will be the same.
     Torque
15.     The ________________ tool gets the disk exactly lined up with the end of the crankshaft and the fly wheel.
     alignment
16.     Keep the jack under the ________________, supporting it until you get some of the bolts in place.
     transaxle
17.     How taut should the clutch release cable be?
     All slack should be gone.
© Educational Video Network, Inc. 2005 - www.evndirect.com
Your leading source for curriculum-based educational videos and DVDs.